TECHNICAL DATA
| MIXING RATIO |
1:1 by volume
Supplied in 400ml cartridges |
|
|
|
| Flexural Strength |
(ASTM D790) |
32N/mm2 |
| Compressive Strength |
(ASTM D695) |
67N/mm2 |
| Tensile Strength |
(ASTM D638) |
15N/mm2 |
| E Modulus |
|
3267N/mm2 |
TEMPERATURE
"C.............. "F |
GEL TIME
MINUTES |
MINIMUM LOADING TIME
HOURS |
5
10
15
20
25
|
41
50
59
68
77
|
210
9
6
5
3
|
18
12
8
6
5
|
ANCHOR SIZE
mm |
HOLE DIAMETER
mm |
TENSION
Kn
Ultimate Pull Out |
FIXINGS PER UNIT
400ml Cartridge |
8
10
12
16
20
|
10
12
14
18
22
|
24
32
52
68
96
|
95
58
36
20
12
|
Tension figures quoted are tested in accordance with BS 5080 part 1 in 63N/mm cubed concrete. In all cases for 16mm and 20mm anchors failure of the concrete blocks was observed before the anchor was dislodged.
The ultimate pull out strength is varied by:
1 The strength of both the substrate and bar.
2 The length of the resin bond to bar.
3 Hole preparation.
4 Anchor seperation.
Safety factors of between 2:1 and 4:1 should be considered depending on the strength and nature of the substrate. Due to the inconsistent nature of hollow blocks and bricks tension figures may vary. Site testing should be carried where necessary to determine the particular suitability. In order to achieve maximum performance the distance between the centres of the anchors should be a minimum of 2.5 x the embedment depth and 1.25 x the embedment depth for minimum edge distances.
STORAGE
Store in a dry area. Do not expaoe to sunlight. Store cartridges nozzle upwards.
HEALTH AND SAFETY
Clan EP4 is classed as an irritant and may cause sensitisation by repeated skin contact. Wear suitable protective clothing such as gloves and overalls. On contact with skin wsh off immediately with plenty of soap and water.
IMPORTANT
This information is based on Clan Products own experience, research and testing and is believed to be reliable and accurate. However as Clan Products cannot know the varied applications of its products no warranty as to the fitness or suitability of its products.
|
